Alkin Compressors is Turkey’s first and only high-pressure breathing air compressor manufacturer. Production facility has a total area of 177,600 sq/ft in Menderes, İzmir. Exports to more than 120 countries. With its expert team, Alkin has an assembly and distribution center in Clifton, NJ since 2015. Alkin Compressors manufactures high pressure air compressors for the airgun industry. Alkin compressors are the lowest RPM air compressor in the market. Low RPM allows the compressor to run cool and continuous without any down time. Extends the maintenance time of the compressors due to less wear and tear on moving parts. Very little maintenance as simple as oil and filter change.
The Alkin W31 has a maximum working pressure of 350 bar, making it one of the only continuous use compressors in the consumer marketplace. It’s also being used by a lot of air gun shops because it can fill up those really large tanks.
One thing to keep in mind is that this compressor requires a 220 volt, 30 amp circuit. If you don’t want to hire an electrician, you can go ahead and buy a dryer plug. Your electric dryer happens to run off of 220 volt and definitely has a 30 amp circuit.
Fill times are extremely important. The fill time on a 74 cu/ft Air Venturi tank is going to take from completely empty to a full or 4500 PSI in as little as 19 minutes!
Overall, this is a great compressor for anyone looking for a powerful and continuous use compressor. It’s perfect for air gun shops and anyone who needs to fill up large Air Venturi tanks quickly. Order yours today from Dirt E. Harry at TopAirGun.com today.
Full Automatic Start / Stop: (B)
Compressors are often used to pressurize air or other gases. They can be controlled by a pressure switch to automatically stop and restart at the upper and lower pressure limits. Pressure switches cut off the electric motor control when the compressor reaches the adjusted upper pressure. When the pressure drops to the adjusted lower pressure, the pressure switches cut in and restart the compressor.
Full Automatic Moisture Drain: (A)
The springs in automatic drain valves are located on top of the piston in high-pressure valves and under the piston in low-pressure valves. This is because the surface area where low-pressure acts is larger than the surface area where high pressure effectively acts on the piston. As a result, the force on the top of the piston is larger and causes it to sit and seal the high-pressure vent port.
Automatic drain valves are controlled by a solenoid. The solenoid receives compressed air from the 2nd stage air inlet and sends it over 4 drain valves, forcing them to stay closed. When the solenoid is de-energized, it removes the control air on the top of the drain valve pistons, allowing the high pressure acting from the bottom of the pistons to open and perform drain operation.
The solenoid valve itself is controlled by a timer installed in the electrical panel. The dual time adjustment on the timer allows adjusting the time period between one and seven minutes during which the solenoid will remain energized (the drain valve will remain closed). The timer also allows adjusting the duration between one and six seconds during which the solenoid will be de-energized (the drain valve will open and perform the drain function).
- Electric (220 volts (30 amps))
- 1450 (100 BAR) to (5000 psi (345 BAR) working pressure
- CFM: 4.9
- Motor Power: 4 hp
- RPM: 1350
- Stages: 3
- Purifier Size: P21
- 4′ Fill Hose: Comes with the Alkin Fill Adapter and a 300 “Spin” DIN male on the output end.
- Weight: 220 lbs.
- Dimensions (inches): 23 x 20 x 35
Fact: if you buy from anyone other than Dirt E. Harry, you could wind up like the Punk who forgot his Fortune Cookie